MDS MDS iNET 900 Spezifikationen PDF herunterladen (Seite 9)

MDS 05-2873A01, Rev. E

NET Series Installation & Start-Up

It is highly recommended that the Access Point unit be installed

first.

With this plan, you can quickly check the operation of each associated

Remote as it is placed on the air.

NOTE:

Transceivers are shipped from the factory set to the “Remote”

mode unless they are marked differently.

Step 1—Mount the Transceiver

Mount the radio to a stable surface. (Fasteners/anchors or screws are

not normally supplied.) Four threaded holes are located on the bottom

of the radio that are suitable for connecting mounting hardware. Use

6-32 x 1/4 inch (6 mm) screws to attach mounting hardware to the

bottom of the radio. Figure 1 shows the mounting dimensions.

Invisible place holder

Figure 1. Transceiver mounting dimensions

Screws used to hold the mounting brackets to the radio

case should be SAE 6-32 and should not extend farther

than 1/4 inch (6 mm) into case. This will prevent dam-

age to the transceiver’s internal PC board.

2.75˝ (7 cm)

7.25˝ (18.4 cm)

CAUTION

POSSIBLE

EQUIPMENT

DAMAGE

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Keine Kommentare

MDS MDS iNET 900 Spezifikationen Seite 9