MDS MX-2104 Spezifikationen PDF herunterladen (Seite 191)

MX-2100/2104 Installation and Operation Manual Appendix F Command Set Description

Commands F-13

Use

1. Type:

DEF CON <ENTER>

The main link selection screen is displayed. The screen lists the I/O slots

(including the options slot) and the main link currently used by each I/O

slot. A typical display is shown below:

KM2100.def con

I/O GROUP OPERATED_HIGHWAY PB[A–>B] PB[B–>A] SWITCH

============================================================================

OP ALL ML-A N/A N/A N/A

1 ALL ML-B N/A N/A N/A

2 ALL ML-A N/A N/A N/A

3 ALL ML-A N/A N/A N/A

4 ALL ML-B N/A N/A N/A

5 ALL ML-B N/A N/A N/A

6 ALL ML-A N/A N/A N/A

7 ALL ML-A N/A N/A N/A

8 ALL ML-A N/A N/A N/A

9 ALL ML-A N/A N/A N/A

10 ALL ML-A N/A N/A N/A

11 ALL ML-A N/A N/A N/A

12 ALL ML-A N/A N/A N/A

Checking Frame Structure…

Updating Frame Structure…

2. Use the space bar to move the cursor to the desired slot number, and press the

F or B key to change the main link used by this I/O slot.

If priority bumping is used, the third row shows the priority assigned to

each module when a flip occurs from main link A to main link B.

If priority bumping and switched backup are disabled, this row shows N/A

for all the I/O slots.

3. Use the space bar and the F and B keys to change the priorities as necessary.

A fourth row appears, showing the priorities for flips from main link B to

main link A.

 If the two main links operate at the same data rate or the switched

backup mode is used, MX-2100 automatically sets the same priorities

for flips in either direction. Then this line shows N/A for all the I/O slots.

 If the data rates of the two main links are different and the priority

bumping mode is used, you can select the priorities for each I/O slot

using the same procedure as above.

1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 242 243

Keine Kommentare

MDS MX-2104 Spezifikationen Seite 191