MDS TransNET 900 Bedienungsanleitung PDF herunterladen (Seite 6)

APPLICATION NOTE: Using Wind Observer II with MDS Trans NET 900 Radio 6

SETUP AND OPERATION

EQUIPMENT

The following equipment is needs to transmit data from a Wind Observer II to a PC using MDS Trans NET

900 radios. Some items are only used for individual configuration of the MDS Trans NET 900 radios

 MDS Trans NET 900

 Wind Observer II GILL sensor

 12 VDC Power supply

 NULL Modem adapter

 RS-422 to RS-232 converter

 PC running Hyper Terminal for Windows

 Antenna (900 MHz to 2.4 GHz)

 RS 232 cable (DB-9)

 RJ-11 to DB-9 adapter

THE MDS TRANSNET 900 SETUP

In this section we are going to configure the MDS Trans NET 900 radios to transmit data from the Wind

Observer II sensor to a PC. We will use a Point-to-Point configuration.

Point-to-Point configuration is a simple arrangement consisting of just two radios (a Master and a

Remote). This provides a half-duplex communications link for the transfer of data between two locations.

The following figure shows a typical Point-to-Point Link.

Requirements:

 MDS Trans NET 900 (2)

 RJ-11 to DB-9 adapter

 RS-232 cable

 Power supply

 Antenna

 PC running Hyper Terminal on Windows

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Keine Kommentare

MDS TransNET 900 Bedienungsanleitung Seite 6