MDS MDS 9710 Series Spezifikationen PDF herunterladen (Seite 25)

MDS 05-3305A01, Rev. D MDS 4710/9710 I/O Guide 17

Error Messages

Below are some possible error messages encountered when using the

HHT:

UNKNOWN COMMAND—The command was not recognized. Refer to the com-

mand description for command usage information.

INCORRECT ENTRY—The command format or its associated values were not

valid. Refer to the command description for command usage information.

COMMAND FAILED—The command was unable to successfully complete. This is

a possible internal software problem.

NOT PROGRAMMED—Software was unable to program the internal radio

memory or the requested item was not programmed.This is a serious internal

radio error. Contact GE MDS.

TEXT TOO LONG—Response to OWN or OWM command when too many charac-

ters are entered. Refer to the command description for command usage infor-

mation.

NOT AVAILABLE—The entered command or parameter was valid, but it referred

to a currently unavailable choice. Refer to the command description for com-

mand usage information.

ACCESS DENIED—The command is unavailable to the user. Refer to the com-

mand descriptions for command information.

EEPROM FAILURE— The INIT command was unable to write to EEPROM. This is

a serious internal radio error. Contact GE MDS.

See Table 9 for a summary of the user commands.

Table 9. Command Summary

Command name Function

ALARM Details Page 19 Read current operating condition of radio.

AMASK [0000 0000–FFFF

FFFF] Details Page 19

Set or display hex code identifying which events

trigger an alarm.

ASENSE [HI/LO] Details

Page 20

Set or display the state of the alarm output signal

to ACTIVE HI or ACTIVE LO.

BAUD [xxxxx abc] Details

Page 21

Set or display the DATA INTERFACE data rate

and control bits.

BUFF [ON, OFF] [xxx]

Details Page 21

Enables or disables the internal radio data buffer.

CTS [0–255] Details Page

Set or display the Clear-to-Send delay in

seconds.

CKEY [ON–OFF] Details

Page 22

Enables or disables the continuously keyed

mode. Note: Remotes cannot receive when

keyed.

DATAKEY [ON, OFF]

Details Page 22

Enables or Disables key-on-data mode

(ON = key-on-data or RTS, OFF = key-on-RTS).

DEVICE [DCE, CTS KEY]

Details Page 22

Set/display device mode.

DKEY Details Page 23 Dekey the radio (transmitter OFF). This is

generally a radio test command.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 57 58

Kommentare zu diesen Handbüchern

Keine Kommentare

MDS MDS 9710 Series Spezifikationen Seite 25

Kommentare zu diesen Handbüchern